Page 31 from 84
By default, the AirStation receives RIP
(Route Information Protocol) informa-
tion only from your local network, and
doesn’t broadcast RIP at all. For large,
complicated network conﬁ gurations,
you may wish to modify this behavior.
Click Apply when you have your desired
Lower on the page, routing information
is displayed. Click Edit Routing Informa-
tion to add a new route manually.
Network Conﬁ g (Route Info)
Page 32 from 84
To conﬁ gure a route manually, enter its
Destination Address and Gateway. Enter
a maximum number of hops allowable in
Metric and click Add.
Network Conﬁ guration (Edit Routing Information)
Page 33 from 84
You may disable Network Address
Translation and IPsec passthrough by
unchecking the appropriate Enable boxes.
If you have a DMZ, enter its IP address
in the IP Address of DMZ box. Incoming
packets containing no recognizable
destination port information will be
redirected to the DMZ’s IP address.
Click Apply when done.
To set a NAT table entry manually, click
Edit NAT Table.
Page 34 from 84
NAT (Manual Entry)
From this page you may manually add
entries into the Address Translation
Table. Click Add New Group when each is
Page 35 from 84
Your AirStation comes pre-conﬁ gured
with basic rules. You may choose which
of these to use by clicking on Add/Delete
Basic Rules and turning to page 36.
To make a custom rule, click on Conﬁ gure
IP Filter (page 37).