Page 31 from 57
Power Display & Power Saving
General Power Saving Mode
On 48w max.
Sleep 7w max.
Power-Save (No Input)
• The LCD panel background is cut when there is no signal input (AC line power consump
tion of 7w or less).
Note:If the monitor is not to be used for an extended period of time, it is recommended
that the monitor be turned off.
For viewing clarity, you can tilt the LCD forward (up to -5 degrees) or backward (up to 90
• In order to protect the LCD, be sure to hold the base when adjusting the LCD.
• For models without a touchscreen take care not to touch the screen.
Page 32 from 57
3-18 Elo Touchmonitor User Guide
Page 33 from 57
C H A P T E R
If you are experiencing trouble with your touchmonitor, refer to the following table. If the prob-
lem persists, please contact your local dealer or our service center. Elo Technical Support num-
bers are listed on page 31 of this manual.
Solutions to Common Problems
The monitor does not respond Check that the monitor’s Power Switch is on. You turn on the
system.Turn off the power and check the monitor’s power cord
and signal cable for proper connection.
Characters on the screen are dimRefer to the Controls and Adjustments section to adjust the brightness.
The screen is blank During operation, the monitor screen may automatically turn off as
a result of the Power Saving feature. Press any key to see if the
Refer to the Controls and Adjustments section to adjust the brightness.
OSD or power buttons don’t work Check to see that they are not locked. See page 15.
“Out of Range” display” Check to see of the resolution or vertical frequency of your
computer is higher than that of the LCD display.
Reconfigure the resolution of your computer to make it less than or
equal to 1280 x 1024. 1280 x 1024 is optimal. See Appendix A for
more information on resolution.
Touch doesn’t work Make sure cable is securely attached at both ends.
Power will not shut off immediately Be sure to depress power button for five(5) seconds when powering
off. Unit includes integrated power down delay function.
Page 34 from 57
4-20 Elo Touchmonitor User Guide
Page 35 from 57
A P P E N D I X
The native resolution of a monitor is the resolution level at which the LCD panel is designed to
perform best. 1928L native resolution is 1280 x 1024. In almost all cases, screen images look
best when viewed at their native resolution. You can lower the resolution setting of a monitor but
not increase it.
Input Video 19.0” LCD
640 x 480 (VGA) Transforms input format to 1280 x 1024
800 x 600 (SVGA) Transforms input format to 1280 x 1024
1024 x 768 (XGA) Transforms input format to 1280 x 1024
1280 x 1024 (SXGA) Display in Native Resolution
The native resolution of an LCD is the actual number of pixels horizontally in the LCD by the
number of pixels vertically in the LCD. LCD resolution is usually represented by
the following symbols:
VGA 640 x 480
SVGA 800 x 600
XGA 1024 x 768
SXGA 1280 x 1024