Page 56 from 85
5.Remove the battery (2).
Reverse this procedure to install the battery.
48 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Page 57 from 85
The display is only spared at the subcomponent level. The full hinge-up is not spared.
Before removing the display assembly, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.Remove the top cover (see
Top cover on page 25).
5.Remove the system board (see
System board on page 39).
To remove the display assembly:
1.Remove the six Phillips PM2.5×4.0 screws (1) and the Phillips PM2.0×2.5 screw (2) that secures the
display assembly to the computer.
CAUTION:Support the display assembly when removing the screws. Failure to support the display
assembly can result in damage to the display assembly and other computer components.
2.Pull the display into the computer to remove hinges from computer (3).
3.Separate the display assembly from the computer (4).
If it is necessary to replace any of the display assembly subcomponents:
1.To remove the display enclosure:
Component replacement procedures 49
Page 58 from 85
NOTE:The display enclosure is available using the following spare part numbers:
809574-001 for red models
809573-001 for silver models
809575-001 for green models
816503-001 for purple models
a.Use a thin plastic tool to run along the entire seam of the display to loosen the cover from the
CAUTION:Top avoid damaging the display, be sure to only run the tool in one direction.
b.Separate the left side (1), top (2), right side (3), and bottom (4) of the display cover from the
NOTE:Separate the cover from display just enough to gain access to the touch control cable that
routes to the connector on the board on the side of the display panel.
The raw display panel is available using spare part number 809548-001 for SVA panels and
809549-001 for UVWA panels.
50 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Page 59 from 85
c.Disconnect the cable from the touch control board (1), and the separate the display enclosure
from the display (2).
Position the display enclosure next to the display panel so you can access the display cable
connected to the back of the display panel.
d.Disconnect the display cable from the back of the display panel by lifting the tape that secures the
cable in the connector (1), and then pull the cable out of the connector (2).
The display cable is available using spare part number 809576-001.
2.To remove the webcam module:
NOTE:The webcam is available using spare part number 807542-001.
a.Lift the webcam module (1) enough to gain access to the cable.
Component replacement procedures 51
Page 60 from 85
b.Disconnect the cable (2) from the module.
3.To remove the display hinges:
NOTE:The display hinges are available using spare part number 809539-001.
a.Position the display enclosure upright.
b.Remove the Phillips PM2.0×2.0 screw (1) from the top of each hinge and the three broadhead
Phillips PM2.5×2.0 screws (2) from the bottom of each hinge that secure the hinges to the display.
52 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts