Page 141 from 174
4The Copy to Floppy dialog box appears.
Select the desired components you want to copy to the
diskette from the Select box. You can select PCL Printer
Driver, PostScript Driver.
Select the floppy disk drive you will use to
insert the diskette.
5Click Copy all disk images.
If you want to copy a portion of the selected component,
select the disk you want to copy in the Disk Images
window, then click Copy selected disk image.
6When prompted, insert a blank, formatted diskette into
the floppy drive, and click Yesto copy the first diskette.
For multiple diskettes, when the first diskette is finished,
you are prompted to insert disk 2.
Make sure you label each diskette in order as you create it:
PCL Printer Driver, disk 1 of 2, etc.
path of the
floppy drive you
Making Installation Diskettes
number of disks
required to copy
component. Select the
want to copy.
Page 142 from 174
The instructions to install PCL Printer Driver, PostScript
Driver are same. Take the following steps:
1Insert the first diskette (if the selected software diskettes
are more than one) which contains the desired
installation software; PCL Printer Driver, PostScript Driver.
2From the Startmenu, select Run.
3Type A:\setup.exein the Open box and click OK.
(if your floppy drive is not A, substitute the correct
4Follow the on-screen instructions to complete the
7If you have more than one disk, insert the next disk and
click Yes. Repeat this step for a third disk if necessary.
8When the diskettes have finished copying, click Closein
the Copy to Floppy dialog box. Then click Exitin the
SAMSUNG PRINTER SETUP dialog box.
Installing Software from Diskettes
Making Installation Diskettes
Page 143 from 174
Your printer is a full-featured laser printer that has been
optimized to meet most of your printing needs. Recognizing
that each user may have different requirements, however,
Samsung makes several options available to enhance the
This appendix provides information on the following topics:
Closing The Printer Cover
Understanding the Printer Control Board
Network Option Card
(Installed in ML-7300N already)
Installing Serial/LocalTalk or
Serial/IrDA option card
Optional Tray 2
Page 144 from 174
Never remove the printer control board while the printer is
To avoid the possibility of electrical shock, always disconnect the
power cord when installing or removing ANY internal or external
The control board and internal printer options
(SIMM, Network interface) are sensitive to static electricity.
Before installing or removing an internal option,
discharge static electricity from your body by touching
something metal, such as the metal back plate on any device
plugged into a grounded power source.
If you walk round before finishing the installation, discharge any
static electricity again.
Discharge Static Electricity
Disconnect The Power Cord
Page 145 from 174
3Remove the printer cover.
aOpen the rear cover.
bRemove the two screws from
the back of the printer.
Save the screws.
cGrasp the cover
(as illustrated) and pull it
firmly toward the rear of the
printer until it stops.
dRemove the cover from the
Complete the following steps before you install the printer options.
1Unplug the printer power cord.
2Disconnect all cables from the back of the printer.
eRemove the five screws from
the metal plate covering the
fRemove the plate.