Page 61 from 174
Any error in the process of upgrading may result in disabling
PortThru. In this case, perform the following steps.
1Select the Upgrade Firmwaremenu item under the
Maintenancemenu in SyncThru.
2You can see the Choose the Upgrade Firmware Filedialog box.
3Check “Wait Printer Request” and “Set as Default Download”.
4Select the Firmware file Nameyou downloaded and its path,
and then click Start.
5You will see the message ”Please set the values through the
FRONT Panel to initiate FLASH Upgrade”. Click OK.
After this procedure, move to printer which you want to
update and do as following procedure.
In Front Panel of the printer
6Press On Line. OFFLINEappears on the display.
7Press Menuuntil NETWORK MENUappears on the display.
8Press Itemuntil UPDATE appears on the display.
9Select YESby pressing the Valuebutton.
11Press Itemuntil BOOT SVR appears on the display.
12Press Valueuntil WINDOWS appears on the display.
Upgrading the Firmware in Abnormal Cases
Page 62 from 174
14Set the IP address of the WINDOWS pc running SyncThru
in step1. For example, if the IP address is 18.104.22.168,
follow these steps:
a Press Itemuntil SV-IP B1appears on the display.
b Press Valueuntil 155appears on the display.
c Press Enter/Cancel.
d Press Itemuntil SV-IP B2appears on the display.
e Press Valueuntil 213appears on the display.
f Press Enter/Cancel.
g Press Itemuntil SV-IP B3appears on the display.
h Press Valueuntil 211appears on the display.
i Press Enter/Cancel.
j Press Itemuntil SV-IP B4appears on the display.
k Press Valueuntil 12appears on the display.
l Press Enter/Cancel.
15Reset printer and the firmware will be upgraded.
Notes:After the ”Completed. Network Card will start about 30secs
later” message is displayed on SyncThru, click OK.
It may take a few seconds to write the new file to Firmware.
Normally 30 seconds is sufficient.
Page 63 from 174
Print Media Print Media
This chapter will help you understand what kind of paper
you can use with the ML-7300 series printer and how to
properly load paper in the different paper trays for the best
Topics included in this chapter are:
- Using the Multi-Purpose Tray
- Using the Manual Feed.
- Letterhead/Prepunched Paper
Page 64 from 174
Multi-Purpose tray provides a convenient way to print envelopes, transparencies,
or other type of media without having to unload the other tray.
To load paper in the Multi-Purpose tray, proceed as follows.
Using the Multi-Purpose Tray
1Pull the Multi-Purpose tray
2Slide the length guide out toward
Page 65 from 174
Notes: • Do not fold or crease the paper.
• Place the paper with the recommended print side face up.
3Flex the sheets back and forth
to loosen them, then fan them.
4Place the paper against the side
of the Multi-Purpose tray with
the recommended print side face
up and the top edge going in
first toward the printer as
5Adjust the paper guide to the
size of the paper inserted by
pushing the guide.