Page 11 from 33
NOTEBe sure the pedestal base is securely locked before continuing with the setup.
Figure 3-2 Rear Components
ProvisionProvides slot for use wi th cable security locks.
SwitchTurns off all power to the monitor.
ConnectorConnects the AC power cord to the monitor.
4DVI-D ConnectorsConnects the DVI-D signal cable to the monitor.
ConnectorConnects the monitor USB hub to a host USB port/hub.
6 USB Downstream
Connectors Connects optional USB devices to the monitor.
Rear Components 5
Page 12 from 33
Selecting the Signal Connectors and Cables
The monitor features two DV I-D dual-link connectors capable of supp orting high resolution digital input.
NOTEThe high resolution of the monitor requires a dual-link DVI-D input signal. The monitor
can only display a 2560 x 1600 resolution; therefore, the computer must support a high-
performance video card that is capable of scaling all video modes to 2560 x 1600. The monitor
does not support a VGA (analog) video signal input.
Connect one of the DVI-D signal cables provided to the DVI-D connector on the monitor and the other
end to the DVI-D connector on the computer.
The monitor will automatically determine which inputs have valid video signals. The inputs can be
selected by pressing the Input button on the front panel. Refer to the
Front Panel Controls section for
Figure 3-3 Connecting the DVI-D Signal Cable
6 Chapter 3 Setting Up the MonitorENWW
Page 13 from 33
Connecting the Monitor
1.Place the monitor in a convenient, well- ventilated location near your computer.
2. Connect one end of the USB hub cable to the USB connector on the rear panel of the computer,
and the other end to the upstream USB connector on the monitor.
Figure 3-4 Connecting the USB Cable
WARNING! To reduce the risk of electric shock or damage to the equipment:
• Do not disable the power cord grounding feature. The grounding plug is an important safety
• Plug the power cord in a grounded (earth) outlet that is easily accessible at all times.
• Disconnect power from the product by unpluggin g the power cord from the electrical outlet.
For your safety, do not place anything on power cords or cables. Arrange them so that no
one may accidentally step on or trip over them. Do not pull on a cord or cable. When
unplugging from the electrical ou tlet, grasp the cord by the plug.
ENWW Connecting the Monitor 7
Page 14 from 33
3.Connect one end of the power cable to the AC power connector on the back of the monitor, and
the other end to an electrical wall outlet.
Figure 3-5 Connecting the Power Cable
4. Place the cables through the cable management channel on the back of the pedestal base.
Figure 3-6 Using the Cable Management Feature
8 Chapter 3 Setting Up the MonitorENWW
Page 15 from 33
Adjusting the Monitor
1.Adjust the monitor's panel forward or backw ard to set it to a comfortable eye level.
Figure 3-7 Tilting the Monitor
2. Swivel the monitor to the left or right for the best viewing angle.
Figure 3-8 Swiveling the Monitor
ENWW Adjusting the Monitor 9