Page 16 from 35
3.Install the two large screws included with the stand into the two lower VESA mounting holes on
Figure 2-13 Installing the Lower Mounting Screws
4.Place the stand mounting bracket on the rear of monitor so that the keyholes on the bracket
align with the two large screws on the monitor then slide the mounting bracket toward the top of
the monitor so that the screws heads are captured inside the keyholes.
Figure 2-14 Aligning the Mounting Bracket
10 Chapter 2 Setting Up the Monitor
Page 17 from 35
5.Install the two small screws included with the stand into the upper two VESA mounting holes to
secure the mounting bracket to the stand.
Figure 2-15 Installing the Upper Mounting Screws
Routing Cables through the Optional Monitor Stand
The optional stand has a clip on the neck of the stand and a hole on the base of the stand for routing
1.Remove the clip on the neck of the stand by pressing inward on one side of the clip (1) and
pulling outward on the other side of the clip (2).
Figure 2-16 Removing the Cable Routing Clip
Attaching an Optional Monitor Stand 11
Page 18 from 35
2.Replace the clip on the neck of the stand so that it secures the cables.
Figure 2-17 Replacing the Cable Routing Clip
3.Route the cables through the hole in the center of the base.
Figure 2-18 Routing Cables through the Base
12 Chapter 2 Setting Up the Monitor
Page 19 from 35
Adjusting the Optional Monitor Stand
You can adjust the monitor stand height and tilt to a variety of positions. Choose a position that is the
most ergonomically appropriate for your usage.
NOTE:Tilt range is -5 degrees forward to +60 degrees backward.
Figure 2-19 Adjusting the Optional Monitor Stand
Mounting the Monitor
The monitor panel can be attached to a wall, swing arm, or other mounting fixture.
NOTE:This apparatus is intended to be supported by UL or CSA Listed wall mount bracket.
1.Remove the four screws from the VESA mounting holes on the back of the monitor.
CAUTION:This monitor supports the VESA industry standard 100 mm mounting holes. To
attach a third-party mounting solution to the monitor, four 4 mm, 0.7 pitch, and 10 mm long
screws are required. Longer screws must not be used because they may damage the monitor. It
is important to verify that the manufacturer’s mounting solution is compliant with the VESA
standard and is rated to support the weight of the monitor display panel. For best performance, it
is important to use the power and video cables provided with the monitor.
2.To attach the monitor to a mounting fixture, insert the four screws that were previously removed
through the holes on the mounting fixture and into the mounting holes on the monitor. Follow the
manufacturer’s documentation provided with the mounting fixture for additional assembly
3.Connect the required cables to the monitor panel and PC.
Connecting the Cables
NOTE:If the monitor is attached to the optional stand, route the cables through the stand as
Routing Cables through the Optional Monitor Stand on page 11.
1.Place the monitor in a convenient, well-ventilated location near the computer.
Mounting the Monitor 13
Page 20 from 35
2.Remove the cable connection cover on the rear of the monitor by pressing the two ribbed areas
at the top of the cover (1) and pulling the cover straight down and off the monitor (2).
Figure 2-20 Removing the Cable Connection Cover Plate
3.Depending on your configuration, connect either the DisplayPort, DVI, or VGA video cable
between the PC and the monitor.
●Figure 2-21 Connecting the DisplayPort Video Cable
14 Chapter 2 Setting Up the Monitor