Page 11 from 35
2.Slide the top cover plate on the back of the monitor up approximately 12mm (1/2 inch) to access
two of the rear panel screws. Remove the cable connection cover plate by pressing the two
ribbed areas at the top of the cover (1) and pulling the cover straight down and off the monitor
(2) to access two more of the rear panel screws.
Figure 2-4 Removing the Top and Bottom Cover Plates
3.Remove the eight screws that attach the rear panel to the monitor.
Figure 2-5 Removing the Rear Panel Screws
Installing Optional USB Modules 5
Page 12 from 35
4.Lift the rear panel up and off the monitor.
Figure 2-6 Removing the Rear Panel
5.Remove the two screws that attach the USB cover plate to the monitor (1) then slide the cover
plate off the monitor (2). Remove only the cover plate that is in the location where you want to
install the USB module.
Figure 2-7 Removing the USB Cover Plate
6 Chapter 2 Setting Up the Monitor
Page 13 from 35
6.Pull the plug that is inserted in the USB port out of the port.
NOTE:Some models do not have plugs in the USB ports.
Figure 2-8 Removing the USB Plug
7.Slide the module screw hole cover plate back (1) and insert the USB connector on the module
into the USB port (2).
Figure 2-9 Inserting the USB Module
Installing Optional USB Modules 7
Page 14 from 35
8.Install the two screws that were previously removed (1) and slide the cover plate on the module
forward to cover the screws (2).
Figure 2-10 Securing the USB Module
9.Replace the rear panel and insert the eight screws that attach the panel to the monitor.
Figure 2-11 Replacing the Rear Panel
8 Chapter 2 Setting Up the Monitor
Page 15 from 35
10.Slide the top cover plate down and replace the cable connection cover plate.
Figure 2-12 Replacing the Top and Bottom Cover Plates
11.Ensure that the USB upstream cable is connected between the monitor and the PC.
12.Install the applicable software and drivers for the module(s) according to instructions provided
with the accessory.
Attaching an Optional Monitor Stand
The optional monitor stand is available from HP (sold separately). The stand attaches to the 100mm
VESA mounting holes on the rear panel.
1.Place the monitor panel face down on a flat surface covered with a clean, dry cloth.
2.If there are screws installed in the VESA mounting holes on the rear panel, remove the screws.
Attaching an Optional Monitor Stand 9