Page 136 from 228
Replacing the 3G Antenna Cable
Replacing the Power Board
1.Insert the 3G cables through the chassis.2.Push the cables all the way through and place
them in the cable channel.
3.Replace the adhesive tape to hold the cables in place.
1.Place the Power Board in the chassis as shown.2.Replace the two securing screws.
Page 137 from 228
Replacing the eKey Board
3.Press down on the FFC to attach the adhesive strip
to the chassis.4.Connect the FFC and close the locking latch.
1.Place the eKey Board in the chassis as shown.2.Press down on the FFC to attach the adhesive
strip to the chassis.
3.Replace the two securing screws.4.Connect the FFC and close the locking latch.
Page 138 from 228
Replacing the Keyboard
1.Turn the keyboard over and place it on the chassis.
Reconnect the Fine Track FFC and close the
locking latch.2.Reconnect the Keyboard FFC and close the
3.Turn the Keyboard over and place it in the chassis as shown. Push down in the areas indicated to locate the
4.Replace the two securing screws.5.Turn the computer over and replace the single
securing screw in the memory bay.
Page 139 from 228
Replacing the Switch Cover
IMPORTANT:The LCD module must be fully open in the horizontal position to replace the switch cover.
1.Insert the left side of the Switch Cover as shown
.2.Lower the cover into place and press down from
left to right to secure it.
3.Turn the computer over and replace the two securing screws.
Page 140 from 228
Replacing the ODD Module
1.Align the ODD bezel with the ODD module and
push it into place.2.Replace the ODD board on the ODD module by
reconnecting the interface as shown
3.Replace the ODD bracket and secure it in place with the four screws.
4.Slide the ODD module into the chassis until a click is heard and the module is flush with the casing.