Page 126 from 228
11 6Chapter 3
Replacing the Modem Module
1.Place the Modem module on the mainboard,
ensuring the connection on the base of the module
is well seated.2.Replace the two securing screws.
3.Reconnect the modem cable to the module.4.Press down on the adhesive pad to reattach the
cable to the mainboard.
5.Reconnect the RJ-11 cable.6.Route the remaining cable around the edge of the
Modem module, as shown, and reconnect it to the
Page 127 from 228
Chapter 311 7
Replacing the Bluetooth Board
Replacing the Speaker Modules
1.Reconnect the cable to the Bluetooth module.
NOTE: The cable connector is right way up when
the blue spot is visible.2.Replace the Bluetooth module as shown.
3.Reconnect the Bluetooth cable to the mainboard as shown.
NOTE: The cable connector is right way up when the blue spot is visible.
1.Replace the left and right Speaker modules in the Upper Case.
Page 128 from 228
11 8Chapter 3
2.Lift the mylar covering and slide the speaker cable
underneath into the cable channel.3.Replace the mylar and ensure the speaker cable is
positioned as shown.
4.Replace the four securing screws as shown (two per module).
Page 129 from 228
Chapter 311 9
Replacing the TouchPad Bracket
IMPORTANT:The Touch Pad cannot be removed individually. To replace the Touch Pad, replace the entire
1.Insert the bracket into the upper cover, top edge
first, to engage the securing clip.2.Rotate the bracket down into the upper cover as
shown, ensuring that the four pins are located
3.Replace the TouchPad FFC cable and lock it in place with the cable latch.
4.Replace the two securing screws.
Page 130 from 228
Replacing the Finger Print Reader
Replacing the Card Reader Module
1.Replace the Finger Print Reader board in the upper
cover. 2.Press down on the adhesive pads to secure the
module in place.
3.Replace the bracket as shown.4.Replace the single securing screw.
1.Replace the module in the upper case as shown.2.Slide the module in the direction shown to engage
the securing clips.