Page 121 from 228
15.Replace the Camera Module in the LCD cover.16.Connect the Camera Module cable as shown.
17.Connect the right Inverter board cable as shown.18.Connect the left Inverter board cable as shown.
19.Replace the single securing screw as shown.
NOTE: Tuck the cables in securely to prevent damage to the cables or module.
Page 122 from 228
11 2Chapter 3
Replacing the LCD Bezel
1.Ensure that the cables are correctly situated and that no trapping will occur when the bezel is replaced.
2. Hold the locking latch in the open position and
place the LCD bezel over the latches as shown.3.Press the bezel down around the edges to snap it
4.Replace the four securing screws and the four screw caps on the LCD module.
Page 123 from 228
Chapter 311 3
Main Module Reassembly Procedure
Replacing the CPU
Replacing the CPU Fan
1.Carefully turn the mainboard upside down (CPU
side up), and insert the CPU into the CPU bracket
as shown.2.Using a flat-tipped screw driver, lock the CPU in to
the socket as shown.
1.Place the CPU Fan on the mainboard as shown.2.Replace the three securing screws as shown.
3.Reconnect the CPU Fan cable as shown.
Page 124 from 228
11 4Chapter 3
Replacing the Thermal Module
Replacing the USB Board
1.Align and place the Thermal Module on the
mainboard as shown.2.Replace the four securing screws (in numerical
order from screw 1 to screw 4) in the Thermal
1.Place the USB Board in the chassis as shown.2.Replace the two securing screws.
Page 125 from 228
Chapter 311 5
Replacing the Mainboard
1.Place the mainboard into the chassis, front edge first, ensuring that the I/O ports pass through the casing.
2.Pull out the left side of the casing to accommodate
the left I/O ports as shown.3.Reconnect the mainboard and USB Board by
pinching them together in the area shown.
4. Replace the single securing screw.
NOTE: Make sure the I/O ports are positioned correctly through the lower cover, and the screw sockets are
visible through the mainboard.