Page 86 from 228
7.Remove the four securing screws (two on each side) connecting the LCD module.
8.Carefully remove the LCD module from the chassis.
(red callout)M2*10 2
(green callout)M2*4 2
Page 87 from 228
Removing the Upper Cover
1.See “Removing the Battery Pack” on page 50.
2.See “Removing the LCD Module” on page 75.
3.Turn the computer over. Remove the sixteen screws on the bottom panel.
(red callout)M2*10 10
(green callout)M2*4 6
Page 88 from 228
4.Turn the computer over and disconnect the four cables from the mainboard as shown.
Disconnect A as shown.
Pull back the securing latch and disconnect B as
Pull back the securing latch and disconnect C as
shown.Pull back the securing latch and disconnect D as
Page 89 from 228
5.Remove the single screw on the top panel.
6.Lift the upper cover off the chassis, top edge first, as shown.
7.Moving from top to bottom, pry off the upper cover as shown.
Upper Cover M2.5*4 1
Page 90 from 228
Removing the Card Reader Module
1.See “Removing the Upper Cover” on page 77.
2.Turn the Upper Cover over. Remove the single securing screw from the Card Reader.
3.Slide the module in the direction shown to clear the securing clips.
4.Lift the module and carefully remove the FFC cable from the adhesive pads, as shown, to remove the module.