Page 111 from 182
Replacing the LCD Bezel
18.Replace the securing tapes from the left and right sides of the Inverter board as shown.
NOTE: Tuck the cables securely to prevent damage to the cables or module.
1. Align the edge of the bezel with the bottom cover and replace the LCD Module.
2.Replace the two upper and two lower bezel screw caps. Remove the four securing screws from the LCD
Page 112 from 182
Main Module Reassembly Procedure
Replacing the CPU
Replacing the Thermal Module
1.Carefully turn the mainboard upside down (CPU
side up), and insert the CPU into the CPU bracket
as shown.2. Using a flat-tipped screw driver, lock the CPU in
the socket as shown.
1.Align and place the Thermal Module in the
mounting as shown.2.Tighten the four (4) securing screws from the
Page 113 from 182
Replacing the CPU Fan
1.Align and place the Fan Module in the mounting as
shown.2.Tighten the securing screw on the module.
3.Connect the fan module cable to the mainboard.
Page 114 from 182
Replacing the RJ-11 Port
Replacing the Mainboard
1.Push the jack in as shown.2.Using the tweezers, grasp the end of the cable and
press down to attach it to the base.
3.Connect the RJ-11 cable to the modem module.
1.Tighten the two (2) securing screws on the mainboard.
Page 115 from 182
2.Turn the base rightside up, and connect the bluetooth cable to the bottom right of the mainboard as shown.
3.Turn the lower base over on a clean surface, and connect the DC-IN cable as shown.
IMPORTANT:Ensure the cable can easily pass through the lower cover during the process.