Page 76 from 182
Removing the LCD Module
1.Remove the Battery Pack. See “Removing the Battery Pack” on page 46.
2.Remove the Lower Covers. See “Removing the Lower Covers” on page 49.
3.Remove the WLAN Module. See “Removing the WLAN Module” on page 52.
4.Remove the Antenna. See “Removing the Antenna” on page 64.
5.Remove the two securing screws from the bottom of the chassis.
6.Turn the computer over. Disconnect the the LCD cable from the top panel.
LCD Module M2.5*8(NL) 2
Page 77 from 182
7.Remove the four securing screws (two on each side) connecting the LCD module.
8.Carefully remove the LCD module from the chassis.
(Red callout)M2.5*9 2
(Blue callout)M2.5*5 2
Page 78 from 182
Removing the Upper Cover
1.See “Removing the Battery Pack” on page 46.
2.See “Removing the LCD Module” on page 66.
3.Turn the computer over. Remove the fifteen screws on the bottom panel.
Lower Cover M2.5x9 16
Page 79 from 182
4.Turn the computer over and disconnect the seven cables from the mainboard as shown.
Disconnect A as shown. If necessary, remove FFC G
before beginning.Pull back the securing strip and disconnect B and C
Page 80 from 182
5.Remove the single screw on the top panel. Remove the antenna cables from the housing and
pull back away from the upper cover.Release the securing latches and disconnect E as
Disconnect the Power Board FFC (E) first before
removing FFC D. Pull back the locking latches to
release D.Release the securing latches and disconnect F as
Release the securing latches and disconnect G as shown.