Page 66 from 119
Reconnect the Audio DJ board
1.Reconnect the ribbon cable and the other.
2.Use another tape to secure.
3.Place the Audio DJ board back to position.
4.Secure the screw.
5.Reconnect the Audio DJ cable and the reconnect the other side.
Place the system cover back to position
1.Place the system cover back to position.
2.Secure the four screws on the rear panel.
3.Secure the group of six, the group of eight and the group of four screws as shown here.
Page 67 from 119
4.Secure the three screws here.
5.Reconnect the touch pad ribbon cable.
Reconnect the LED cable
1.Attach the LED cable to the board.
2.And the LED power cable to the board.
3.Secure the four screws on the LED board.
4.Reconnect the LED cable.
Place the keyboard back to position
1.Reconnect the keyboard ribbon cable.
2.Place the keyboard back to position.
3.Secure the six screws for the keyboard.
Page 68 from 119
Place the MDC cable back to position
1.Place the MDC cable back to position.
2.Reconnect the MDC header.
3.Fix the wire by the slot.
Reconnect the sub-woofer
1.Place the subwoofer back to position.
2.Secure the two screws for the sub-woofer.
3.Reconnect the sub-woofer connector.
Place the LED cable back to position
1.Place the LED cable back to position.
2.Fix the wire by a tape. And the other.
Page 69 from 119
Place the side mount back to position.
1.Place the side mount back to position.
2.Secure the side mount.
3.Repeat the same procedure on the other side.
4.Secure the wire with a tape.
Place the wireless antenna back to position
1.Place the wireless antenna back to position.
2.Secure the antenna on the one side and the other.
3.Secure the wireless module with a tape and the other side.
Page 70 from 119
Reattach the LCD cable
1.Reattach the LCD cable.
2.Secure the connector with a tape and the other side.
Place the inverter board back to position
1.Place the inverter bracket back to position and the other.
2.Secure the two brackets.
3.Place the inverter board back to a mylar.
4.Reconnect the inverter power.
5.Reconnect the inverter cables.
6.Fix the wires and repeat the same procedure on the other side.