Page 51 from 119
2.Repeat the same procedure on the other side bracket.
Remove the LED cable attached on the LCD outer shield.
Remove the subwoofer
1.Disconnect the subwoofer cable.
2.Remove the two screws that secure the subwoofer.
3.Remove the subwoofer.
Page 52 from 119
Release the MDC cable.
Disconnect the cable to the modem header.
Remove the keyboard
1.Remove the six screws the secure the keyboard.
2.Remove the keyboard and disconnect the attached cable.
Remove the LED board
1.Detach the LED ribbon cable.
2.Remove the four screws that secure the LED board.
3.Lift the LED board and disconnect the LED cable at the same time.
Page 53 from 119
4.Disconnect the LED ribbon cable from the LED board.
Detach the front panel
1.Disconnect the touch pad ribbon cable.
2.Remove the three screws as shown here.
3.Turn the unit upside down, and then remove the group of FOUR, the group of EIGHT and the group of SIX
4.And finally the 4 screws on the rear side.
5.Detach the front panel.
Remove the Audio DJ board
1.Disconnect the Audio DJ ribbon cable.
Page 54 from 119
2.Disconnect the other side of the ribbon cable to the Audio DJ board.
3.Remove the screw that secures the Audio DJ board.
4.Remove the DJ board.
Remove the touch pad
1.Remove the mylar here.
2.Disconnect the two ribbon cables to the touch pad.
3.Remove the mylar.
4.Remove the two screws that secure the touch pad.
Page 55 from 119
5.Remove the touch pad bracket.
6.Remove the touch pad.
Remove the touch pad board
1.Remove the four screws that secure the touch pad board.
2.Remove the touch pad board.
Remove the lid switch cable
1.Disconnect the lid switch cable by releasing the screw.
2.Remove the lid switch cable.
Remove the floppy drive
1.Disconnect the floppy cable
2.Remove the three screws
3.Remove the floppy drive.