Page 46 from 119
Detach the wireless card
1.Detach the wireless card.
2.Disconnect the two wireless cables.
Remove moden card
1.Remove the screws on the MDC (modem card)
2.Detach the card from the modem cable.
3.Release the cable
Remove the inverter cover
1. Remove the screws as shown here.
2. Remove the inverter cover.
Page 47 from 119
Detach the upper system cover
1.Remove the two screws on the one side, and the two screws on the other. .
2.Remove the hinge covers on each side
3.Detach the upper system cover (middle cover).
Remove the LCD module
1.Detach the LED cable from the LED board.
2.Remove the screws that secure the hinge. And the other side.
3.Detach the LCD panel from the main unit and place the panel by turning 180 degrees.
4.Release the cables by following the instructions here carefully.
Page 48 from 119
Remove the LCD panel
1.Detach the silicon line pad by following the instruction here. And the other side.
2.Unscrew the three screws on the edge of the LCD panel on both sides.
3.Detach the LCD skirting board (LCD bezel) by following the instruction here.
4.Remove the TEN screws on the side mount.
5.Remove the LCD panel.
Remove the inverter board
1.Remove the tape and disconnect the inverter cable.
Page 49 from 119
2.Follow the same procedure on the other inverter cable.
3.Disconnect the inverter power cable from the inverter board.
4.Remove the mylar that covering the inverter board.
5.Remove the two screws that secure the inverter board bracket.
Page 50 from 119
Remove the mylars
Remove the wireless module
1.Remove the two screws that secure the wireless antenna.
2.Remove the antenna.
3.Repeat the same procedure on the other side.
4.Remove the wireless module
Remove the side bracket
1.Remove the two screws as shown here. Then remove the side bracket.