Page 91 from 135
Main Unit Reassembly
Reassembling the Mainboard, Uppercase, and Lowercase
1.Place the mainboard back to the lower case.
2.Insert the PCMCIA dummy card back to the lower case.
3.Connect the USB FFC to the USB module and latch it well.
4.Place the USB module back to the lower case.
5.Secure the USB module with one screw.
6.Connect the USB FFC to the mainboard and latch it well.
7.Connect the MDC cable to the MDC board.
8.Place the MDC board back to the mainboard.
Page 92 from 135
9.Secure the MDC board with one screw.
10.Connect the speaker cable to the mainboard.
11 .Aim the location of Bluetooth and wireless launch button.
12.Place the upper case back to the lower case.
13.Connect the touchpad board FFC to the mainboard and latch it well.
14.Connect the MIC wire cable to the mainboard.
Page 93 from 135
15.Reconnect the MDC cables as shown.
16.Connect the Audio DJ FFC to the mainboard.
17.Connect the LID switch cable back to the mainboard.
18.Secure the lower case with 22 screws.
19.Secure the upper case with 5 screws.
Reassembling the ODD
1.Place the ODD module back to the main unit.
Page 94 from 135
2. Secure the ODD module with one screw.
Reassembling the LCD Module to Main Unit
1.Place the LCD module back to the main unit.
2.Put the antenna through the hole.
3.Secure the LCD module with two screws on left and right hinges.
4.Connect the LCD cable to the mainboard.
5.Place the keyboard back to the main unit.
6.Connect the keyboard FFC to the mainboard and latch it well.
7.Turn the keyboard over.
Page 95 from 135
8.Secure the keyboard with two screws.
9.Place the middle cover back to the main unit.
10.Close the notebook.
11 .Secure the middle cover with three screws on the rear panel.
12.Connect the power cable to the mainboard.
Reassembling the Bluetooth Module
1.Connect the Bluetooth cable to the Bluetooth module.
2.Place the Bluetooth module to the Bluetooth bracket.
3.Secure the Bluetooth bracket with the two screws.