Page 116 from 180
Replacing the LED Board
1.Place the LED Board into the Lower Cover.
2.Replace the two screws to secure the LED Board to the Lower Cover.
LED Board M2*5 1
Page 117 from 180
3.Connect the LED Board FFC to the LED Board and close the locking latch.
4.Connect the LED Board FFC to the Mainboard and close the locking latch.
Replacing the Bluetooth Module
1.Insert the Bluetooth Module, right side first, into Lower Cover so that it is held by the tab.
Page 118 from 180
2.Connect the cable to the Bluetooth Module.
3.Press on the adhesive strip to attach the cable to the Lower Cover.
4.Connect the Bluetooth cable to the Mainboard.
Replacing the Card Reader Board
1.Place the board into the Lower Cover, right side first so the I/O ports align with the openings in the lower
Page 119 from 180
2.Replace the single screw to secure the Card Reader Board to the Lower Cover.
3.Connect the FFC to the Mainboard and close the locking latch.
4.Connect the FFC to the Card Reader Board and close the locking latch.
Page 120 from 180
11 0Chapter 3
Replacing the Button Board
IMPORTANT: The TouchPad Board cannot be removed from the Upper Cover. To replace the TouchPad Board,
replace the entire Upper Cover.
1.Push the FFC through the cover as shown.
2.Connect the FFC to the TouchPad connector and close the FFC locking latch.
3.Slide the button board under the securing tabs in the Upper Cover as shown.