Page 101 from 180
Replacing the Camera Board
4.Replace the two securing screws.
1.Align the locating slots on the Camera Module with the locating pins on the LCD Module.
2.Place the Camera Module in the LCD Module and press down to secure it in place.
3.Connect the Camera cable as shown.
Page 102 from 180
Replacing the LCD Bezel
1.Replace the bezel bottom edge first as shown. Ensure that the cables are not trapped between the bezel
and LCD Module and pass through the hinge wells.
2.Press down around the edges of the bezel until there are no gaps between the covers.
Page 103 from 180
Main Module Reassembly Procedure
Replacing the CPU
1.Insert the CPU into the socket.
IMPORTANT: be sure to align the pins correctly with the marker on the CPU. Failure to do will likely result in
permanent damage to teh CPU.
NOTE: If replacing only the CPU, make sure to follow the instrucitons for cleaning and replacing thermal pads
as described in “Replacing the Thermal Module” on page 93.
2.Using a flat blade screw driver, rotate the CPU screw 90° counterclockwise to lock the CPU into the
Replacing the Thermal Module
IMPORTANT: Ensure all heat pads are in place before replacing the Thermal Module.
The following thermal pads are approved for use:
• Eapus XR-PE
1.Remove all traces of thermal grease or pad adhesive from the CPU and thermal module using a lint-free
cloth or cotton swab and Isopropyl Alcohol, Acetone, or other approved cleaning agent.
Page 104 from 180
2.Place the pads as shown.
3.Place the Thermal Module onto the Mainboard and insert the screws in order from 1 to 5..
Thermal Module M2*3 5
Page 105 from 180
4.Connect the fan power cable to the Mainboard and replace the adhesive.