Page 96 from 180
IMPORTANT: A strong adhesive is used to secure the Antenna pad in place. Take care not to bend the pad during
5.Remove the cable from the cable channel. Ensure that the cable is free from all cable clips.
Page 97 from 180
LCD Module Reassembly Procedure
Replacing the Antennas
1.Remove the protective covering on the left and right Antenna pads. Place the Antenna pads in the LCD
Module and press down to secure the adhesive in place.
IMPORTANT: be sure the cables pass behind the shielding material as shown.
2.Run the left side cable down the side and along the lower edge of the LCD Module using all the available
3.Run the right side cable down the side of the LCD Module using all the available cable clips. Be sure the
cables pass behind the shielding material as shown.
Page 98 from 180
NOTE: The LCD Module appears as shown when the Antennas are replaced correctly. Ensure that the
Antennas run through the hinge well as shown to avoid trapping when the LCD Panel is replaced.
Page 99 from 180
Replacing the LCD Cable and Brackets
1.Insert the LCD Cable into the panel connector
as shown.2.Secure the connector by replacing the adhesive
strip as shown. Press down to secure the
3.Run the LCD cable along the panel as shown. Press down to secure the adhesive.
4.replace the four screws (two each side) securing the LCD Brackets to the LCD Panel.
Page 100 from 180
Replacing the LCD Panel
1.Replace the LCD Panel top edge first as shown. Lower the Panel in to the LCD Module, ensuring the LCD
cables are not trapped between the panel and the casing.
2.Ensure the cables and Antennas pass through the hinge wells as shown.
3.Press down to secure the adhesive holding the Microphone in place.