Page 86 from 180
4.Using both hands, lift the Thermal Module clear of the Mainboard.
Page 87 from 180
Removing the CPU
1.See “Removing the Thermal Module” on page 75.
2.Using a flat blade screw driver, rotate the CPU screw 90° clockwise to release the CPU from the socket.
3.Lift the CPU clear of the socket.
Page 88 from 180
LCD Module Disassembly Process
IMPORTANT: Cable paths and positioning may not represent the actual model. During the removal and
replacement of components, ensure all available cable channels and clips are used and that the cables are
replaced in the same position.
NOTE: The product previews seen in the disassembly procedures may not represent the final product color or
configuration. The following procedure outlines the steps to disassemble the LCD Module on models with 3G
functionality. Models that do not support 3G do not require the removal of the yellow and blue Antenna cables
LCD Module Disassembly Flowchart
LCD Bezel M2*5 6 86.TG607.004
LCD Panel M2*2 2 TBD
LCD Brackets M2*3 4 86.S0207.001
LCD FPC Cable
Panel from Main
LCD BracketsRem ove
Page 89 from 180
Removing the LCD Bezel
1.See “Removing the LCD Module” on page 69.
2.Starting from the inside top edge, pry the bezel away from the panel. Continue moving along the top,
prying the bezel away from the LCD Module. If necessary, use a plastic pry to release the corners of the
3.Work down the sides as shown, then pry apart the bottom edge to remove the bezel.
4. Lift up the bezel and remove it from the LCD Module.
Page 90 from 180
Removing the Camera Board
1.See “Removing the LCD Bezel” on page 79.
2.Disconnect the cable from the Camera Board as shown.
3.Remove the Camera Board from the LCD Module.