Page 71 from 180
Removing the Card Reader Board
1.See “Removing the Upper Cover” on page 53.
2.Open the locking latch and disconnect the FFC from the Card Reader Board.
3.Remove the two screws securing the Card Reader Board to the Lower Cover.
Page 72 from 180
4.Tilt the board up as indicated and remove the board from the Lower Cover, left side first to release the I/O
Page 73 from 180
Removing the Speaker Module
1.See “Removing the LED Board” on page 58.
2.See “Removing the Card Reader Board” on page 61.
3.Disconnect the Speaker cable from the Mainboard.
4.Remove the three screws securing the Speakers to the Lower Cover.
Speaker Module M2*3 3
Page 74 from 180
5.Lift the right and left side speakers out from the Lower Cover as shown.
6.Remove the Speaker cables from the cable channels. Ensure that the cable is free from all cable clips.
Page 75 from 180
Removing the VGA Board
1.See “Removing the Card Reader Board” on page 61.
2.Remove the single screw securing the VGA Board to the Lower Cover.
3.Lift the VGA Board left side first and turn it over to expose the VGA cable.
IMPORTANT: Do not remove the board from the Lower Cover; the VGA cable is still attached.
VGA Board M2*3 1